iphone 6 otterbox resurgence review

water test all mophie waterproof caseshas passed water testing at our factory, but it's also important you do your own water test to ensure proper assembly and a leak-free seal against liquid, before installing your phone for the first time. assemble your case without your phone byfirmly snapping the two halves together at the corners

iphone 6 otterbox resurgence review, and working your way along the edge to geta good seal. double check the seam around the case so there are no gaps. make sure the headphone port cover andthe usb connector cover are dry and securely closed. weight and submerge the case face-down in water for 30 minutes.

afterwards, remove the case and dry the unitthoroughly with a towel and visually inspect the interior for moisture. use a coin to separate the case andcarefully pull the case apart it you see moisture or water, contact us atmophie.com/support if it's completely dry inside, proceed to install your phone into the case. installation using the included cloth, clean off any dirt or oil from your phone. for optimal display performance, apply the included special film to your phone. slide your phone along the case bottom, all the way onto the lightning connector.

when removing, slide it out by pushing on the bottom of the phone. do not pull up from the top of the phone, as this may damage the lightning connector. press and snap the two halves together, insuring there's a tight seal around the edges and closed ports. double check the seamaround the case so there are no gaps. to ensure consistent protection, repeat the water test without your phone in it every three to four months, and after any major impacts.